EVALUATION OF RAPID INTERPRETATION PRINTER-PROCESSOR

Document Type: 
Document Number (FOIA) /ESDN (CREST): 
CIA-RDP79B00873A002900020039-0
Release Decision: 
RIPPUB
Original Classification: 
C
Document Page Count: 
1
Document Creation Date: 
December 28, 2016
Document Release Date: 
November 15, 2012
Sequence Number: 
39
Case Number: 
Publication Date: 
June 17, 1966
Content Type: 
MEMO
File: 
AttachmentSize
PDF icon CIA-RDP79B00873A002900020039-0.pdf49.22 KB
Body: 
-a"f:.ai e- a n r rt i T I A I Declassified in Part - Sanitized Copy Approved for Release 2012/11/15: CIA-RDP79B00873AO02900020039-0 NPIC/P&DS/D/6-1427 17 June 1966 MEMORANDUM FOR THE RECORD SUBJECT: Evaluation of Rapid Interpretation Printer-Processor On 16 June 1966 the prototype Printer-Processor was partially disassembled to repair and evaluate. Complete evaluation is estimated to require three days due'to the extent of disassembly required. The following items were discovered during this partial evaluation. 1. Four of the nine 0 rings, which guide film through the processor, are missing. Counting from left to right, rings 1, 2, 3, and 5 are missing. The remaining rings,. being concentrated on one side, causes film to skew. This results in film becoming jammed between the upper and lower sets of feed rollers. 2. The endless flat fiber belt, used also to guide film, has numerous worn and frayed spots, especially at the seam. 3. A suggestion, to aid operators to insert film straight, would be to provide a beveled shim on each side of the input orifice. Since the film input guide is below eye level, it is extremely difficult for operators to insert film without skewing. 4. Suggest manufacturer provide.an access panel on future processors. This panel should be located to allow film to be removed when jammed between the lower flat belt mandrel and the first set of lower feed rolls. This would greatly expedite removal of film jams, thereby increasing operating time. At present a jam in this area requires 3 hours to remove. 5. There is no external evidence of wear on gears, bearings, shafts or chain. 25X1 Equipment Performance Section, DB/P&DS FYCIQddd from automatic UO~o&radfn& and I dactassltlcatton Declassified in Part - Sanitized Copy Approved for Release 2012/11/15 :CIA-RDP79B00873A002900020039-0