[DRAFT]

• Document Type: CREST
• Collection: NGA Records (Formerly NIMA)
• Document Number (FOIA) /ESDN (CREST): CIA-RDP78B05171A000400030056-9
• Release Decision: RIPPUB
• Original Classification: K
• Document Page Count: 5
• Document Creation Date: December 28, 2016
• Document Release Date: June 7, 2005
• Sequence Number: 56
• Publication Date: July 2, 1971
• Content Type: MISC

Approved For Release 2005/06/23 : CIA-RDP78BO5171A0004000300 -1
D R.A F T
2 July 1971
1. If a1force of two pounds is
J?r'?'~ca2 ~1~d+2
i~
applied ,to the horizontal
surface at the front of the optical pod mount, vertical displace-
ment shall not exceed 0.005 inches..
2e With the electrical carriage look engaged, and4the table in
a horizontal position, movement in x or y shall not exceed 0.010 inches
with the 'application of 2 lbs. force. With the application of 4 lbs.
.force, the movement in x or y shall not exceed 0.020 inches. The force
shall.he applied in the same direction.as the movement to be measured.-
The riiethod of measurement is as follows:
(a) Specified force applied-in plus direction
(b) Deflection gage zeroed{/,r Avxcer A /1ptecs~D.
3.
parallel to the x or y direction of not-less than 1 pound and not more
than 2.'pounds. This specificationamppik atta? applies to all optics
mount positions not less than 1 inch from the mechanical limits of
position,. shall L..J with an applied force on the optics mount
Specified force applied in minus direction.
Deflection read with minus force applied
The carriage, in manual mode and fully stopped in a horizontal
4:. The motorized carriage with the speed control at minimum shall move at a':rate not. to exceed 0.015 inches per second in either x or y
Approv~d FNG a 2005/06123: CIA-RDP78B05171A000400030056-9
Declass review by
vy
 :,Approved For Release 2005/06123 : CIA-RDP78B05171Ag00400030056-9
direction.. This speed shall be attained within 0.5 seconds of actuation
i
of the:directiok control and without resetting of the speed control.
5'? The motorized carriage with the speed control at maximum, shall
..move at crate df at least 0.250 inches per second. This speed shall
be attained witljin 0.5 seconds of actuation of the direction control
and without resetting the ppeed control.
6.. Control of carriage speed by the - speed control shall Abe linear
6
between the maximum and minimum positions.
7. When the direction control is released, motion of the carriage
shall cease in not more than 0.5 seconds.
8., With the carriage in motion at any speed, and with no re-
setting of the speed control, acceleration of the carriage shall not
exceed::0.001 inches per seond per xxexd second.
V
~~ 9:, chanical control.5capable ofnmoving the optics mount in x
sl
aid y direction shall be incorporated. This control shall be capable
of moving the carriage in increments of not more than'0.001 inch. Dead
motion?of,,this control shall not, exceed 30o if rotational or:0.250
inches.if;?linear. Z. cc 4,,
. 'VA~~'~f!.! ,s~V ur ~a~r?!Y^~'Ywf, ~" -;R'^"lY~ b .
Approved For Release 2005/06/23 : CIA-RDP78BO5171A000400030056-9
 Approved For 2005/06/23 : CIA-RbP78B05171A000400030056-9
.. )' !J , , .I .I (!1 . : SJOHna of'
25X1 ? .Li, .I' r?L'.!_ t",
25X1
25X1
0('-,.(:i t t?i '-I'i' =i:.
I, t?.:i%':i.c: