AIR-FED INCINERATOR

• Document Type: CREST
• Collection: General CIA Records
• Document Number (FOIA) /ESDN (CREST): CIA-RDP78-03642A000600070028-8
• Release Decision: RIPPUB
• Original Classification: C
• Document Page Count: 2
• Document Creation Date: December 22, 2016
• Document Release Date: May 4, 2011
• Sequence Number: 28
• Publication Date: August 25, 1959
• Content Type: MEMO

Sanitized Copy Approved for Release 2011/05/05: CIA-RDP78-03642A000600070028-8
STANDARD FORM ND. BO
ERNMEN
Chief, Engineering Division, TSS
FROM :Chief, Physical Security Division, 43
ES GOV
DATE: 2 Z' AUb 1959
suaJEc :Air-Fed Incinerator
ade to
is the fly ash the leas
(2) At what burning rate or stack temperature
t noticeable?
covered in your repor
Ash
A? _~---
_
(1) Is it fe h b~ ra11 effectiveness of
without reducing
the incinerator?
an,evaluation reports on
10 This is to confi oftthisrOfficeufor
and a us of the Subject incinerator. FOYong is
pecific points that this office would like to have
the per ormance
of some spe s
a list is
(1) Can the size of the stack be reduced
?
the present incinerator
(2) Can or do your plan to furnish iasbestos
t to be
ill p
covering for the stack that w
installed through a hole in a wooden wall without
danger of setting the wall on fire?
any
(3) Is the present stack an all weather stack?
What is the life expentencY of the
(ls)
present stack?
(5) If the incinerator is located in a room
or on a balcony on the third or fourth floor of a
is the minimum
hat or
seven story building, w
f the stack?
recommended height o
ILLEGIB
Sanitized Copy Approved for Release 2011/05/05: CIA-RDP78-03642A000600070028-8
 Sanitized Copy Approved for Release 2011/05/05: CIA-RDP78-03642A000600070028-8
SUBJECT: Air-Fed Incinerator
C. Auxiliary Power or Generator -
(1) What plans do you have for an auxiliary
source of power for the blower or fan?
(2) It is probable that at some stations it
will be desirable or necessary to locate the
blower and motor away from the incinerator. For
such cases, is it possible to have some type of a
flexible air duct or is a rigid one necessary?
(3) What maintenance, if any, will be
required on the blower and motor?
D. Please comment briefly on any proposed changes or
modifications that you feel are necessary on the present model
and the length of time that they will require.
Be How long do you anticipate it will take to fabricate a
model half the size of the present one?
(0NA DE1pI!AL
Sanitized Copy Approved for Release 2011/05/05: CIA-RDP78-03642A000600070028-8